Reconfigure a Dell RAID (PERC) Controller through the Dell iDRAC Using racadm

Published September 3, 2014 • Updated January 10, 2019


While setting up an OpenStack Swift cluster, I had five Dell R720 servers with incorrectly configured RAID arrays. The two operating system hard drives were configured in a RAID1 array, as expected, but the 24 data hard drives were configured in two RAID5 arrays. The data hard drives in OpenStack Swift storage nodes should not be in a RAID array; Swift simply wants each hard drive on its own.

You can reboot most of Dell’s enterprise servers into the Dell RAID (PERC) Controller to get access to a GUI to re-configure the RAID arrays. But, with five servers and 24 disks on each, using the GUI would have been a very tedious and time consuming task. So, I began looking into what the racadm command was capable of.

You can SSH to the IP address of a Dell iDRAC and use the racadm command to run all sorts of commands. Luckily, racadm has a set of commands that allow you to reconfigure the RAID arrays.

Continue reading...